Help

Round up to next 1.5kg

Topic Labels: Formulas
2297 2
cancel
Showing results for 
Search instead for 
Did you mean: 
Tyrone_Elliott
5 - Automation Enthusiast
5 - Automation Enthusiast

I’m a bit of a newbie and my apologies if this covered elsewhere, I just can’t seem to find the right answer.

I have this formula below to calculate the total weight/value based on calculations below.

I am trying to round up the total to the next 1.5kg because the product comes in tins of 1.5kg.

So I need to calculate:
IF(Fumigant=“FUMITOXIN (ALP)”,ROUNDUP(({H1 vol}Dosage3.0/1000/1.5)*1.5)))

H1 Volume= 5314 * Dosage=1.0 3.0/1000/1.51.5 at the moment it’s equaling 16kg and it should be 16.5

How do i get it to display the .5? Formatting has been set to Decimal 1.00

16.5kg / 1.5kg = 11 TINS

I hope I’m making sense

2 Replies 2

There’s probably a way to make this work using ROUNDUP(), but having been an English major, I took the low road and did it this way:

IF(
    MOD(
        ({H1 Vol}*{Dosage}*3.0)/1000,
        1.5
        )>0,
    (INT((({H1 Vol}*{Dosage}*3.0)/1000)/1.5)+1)*1.5,
    ({H1 Vol}*{Dosage}*3.0)/1000
    )

Essentially, it checks to see if the calculated amount is evenly divisible by 1.5. If it is, fine; if not, it takes the integer quotient, adds 1, and multiplies the result by 1.5. I tossed a few numbers at it, and it seemed to work — but because of the way Discourse (the software running this forum) interpreted your embedded '*'s, I had to guess at your formula and field names, so you’ll want to double-check my work.

Hi @Tyrone_Elliott - the formula you’ve posted above has got a bit mashed in the post formatting so hard to see exactly what you’re using, but a couple of thoughts:

  1. ROUNDUP should always have a precision - precision of 0 rounds up to the next integer value. Because of the formatting, I couldn’t figure out if the precision value is there or not.

  2. Worth trying to calculate the total weight value first (in one column) then do the roundup in another column - sometimes easier to debug and figure out what is going on (you can always combine these down to a single field/column once you have it working correctly).

To answer your question though, ROUNDUP should do the trick. My example below (I’ve simplified the data, but hopefully still valid) illustrates:

Screenshot 2019-04-03 at 09.04.25.png

So in this case, “Value” is your calculated value; “Exact” is a formula:

Value/1.5

To show the exact number of tins required; “Roundup” is a formula on “Exact”:

ROUNDUP(Exact, 0)

Hope this helps!

JB