Skip to main content

Hello everyone! 👋


I would like to know if I am the only one getting crazy about this… is it a bug??


VERY often, when I move the scrolling cursor up and down in my list, then let it go, it still keeps following my mouse up/down movement (while losing my position). I then have to find the record line again and click the cursor again so it finally let it go. I had this problem on the horizontal scrolling bar too. I haven’t seen this problem in any other software that I use, and it is time and nerve consuming!!


I hope I am not the only one… I would then report it as a probable bug!


That said, another point on those scrolling bar: they are uselessly too thin, aren’t they? It is often hard to see and catch them. I understand that it is probably to make AT looks good (it does), but it is not practical. I would prefer a good classic and ugly but efficient scrolling bar. Anyone thinking the same?


Thank you all 🙂

up?


No one ever faced that problem?


This is a bug that I run up against all the time. Windows 10 PC using a WACOM tablet. 


Not on my side! But it seems to be more of a hardware issue maybe?

Mike, Consultant @ Automatic Nation


I wonder how I would begin to troubleshoot. Any ideas?


I get this problem all the time with left-right scrolling. It has driven me crazy forever.

 

The other bug I get all the time is when you hover over a view heading and the grey box comes up (with ‘created by’ info, etc). Sometimes when you move the cursor off the view heading the grey box stays in place. The only way to clear it is to hover over the view heading again and move the cursor ‘through’ the grey box.

 


Reply